You don't need any tools for this install. Install is ratted:
Very Easy. |
 |
| Step 3. Wiggle off the plug so it is not attached to the bulb prongs. See pic below. |
 |
| Step 4. Pull rubber covering off by pulling
on the small tab that says (Top) See pic below. |
 |
| Step 5. Find the wire spring and push in and up on the part that sticks out, so that the wire spring is now free to swing away. See pic below. |
 |
| Step 6. Swing open the wire spring, far
enough so you can pull out bulb.
Step 7. Replace new bulb, by matching
up the three slots make sure that the top prong is on top. Step 8. Swing the wire spring back into poison and then reclip it back in so that the wire spring in back behind the latch by pushing in and down. Step 9. Push rubber cover back on until it lightly snaps into poison, making sure that tab is on top. Step 10. Plug the plug-in back onto the bulb prongs. There, your all done. |